Hardware Installation
IP PTZ SPEED DOME is designed to be installed using a standing bracket on the wall or ceiling.
Note:
• It is recommended that megapixel lens be used to optimize performance.
• Please keep the lens clean.
• Any foreign objects and nger marks on the lens can cause inferior image quality in low light level
conditions
M156-SPDNi120HD-001
MegaPixel Network Camera
KNC-SPDNi120HD
Installation Guide
Table of Contents
INTRODUCTION
PACKAGE CONTENTS
HARDWARE INSTALLATION
IP ADDRESS ASSIGNMENT
Introduction
IP PTZ SPEED DOME Installation Guide
This installation guide provides instructions for installing the Network Camera on
your network. For all other aspects of using the product, please see the User’s
Manual, available on the CD included in this package, or from http://www.ktnc.co.kr
Installation Steps
1. Check the package contents against the list below.
2. Read the product description.
3. Install the hardware, and set RS485 Device Conguration.
4. Set an IP address
5. Set the admin and user ID and password. (See User’s Manual)
Important!
This product must be used in compliance with local laws and regulations.
Package Contents
Camera Wall Mount Bracket Software CD Installation Guide
Screws / Plastic Anchors / L-wrench / Washers / RJ45 coupler
Plastic anchors(4ea)
Screws(4ea)
Washers(4ea)
Safety Wire
Connect the Camera Safety Wire
to the Installation Base.
③
②
①
Setting Dome Camera
The device can communicate with external switching devices such as multiplexers or DVRs
by setting the Rotary switch and Dip switch. Refer to the tables below for setting the dome
camera ID and protocol selection. The total length of the cable for communication should
not exceed 1km.
Setting the address (ID) of dome camera
To prevent wrong operation and malfunctions, each dome camera has a unique address (ID).
The default setting is 0[ID001]. The value of the rotary switch is in hexadecimal.
ex) SW301 : A, SW302 : F
0xAF => ID175
* Check appendix sheet
Dome camera ID setting (Rotary Switch, SW301, SW302)
Important:
PTZ-Device congurations in SETUP must have the same value as the physical rotary & DIP switches.
Setting the protocol of dome camera
Dome camera protocol setting.(DIP Switch, SW303)
Setting the protocol of dome camera
Dome camera protocol setting.(DIP Switch, SW303)
Dome camera baud rate setting.(DIP Switch, SW303)
Important:
PTZ - Device congurations in SETUP must have same value of physical rotary & DIP switches.
Dome camera termination setting Off/On
(NO5, DIP Switch, SW303)
Press the reset switch for more than 10 seconds, the restore the camera to the
function default settings.
SW301
Reset Switch
SW302 SW303
Plastic
Anchors(4ea)
Screws(4ea)
Washers(4ea)
Terminal Block(5p)
Terminal Block(2p)
Coupler
Terminal Block(2p)
L-Wrench
Ferrite Core
In order to reduce the generation of unnecessary signals, Pass the AC 24V and network cable
through the ferrite core and connect it as the drawing.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels